[Oct-2021] Cisco 350-801 Dumps – Reduce Your Chance of Failure in 350-801 Exam
To help you achieve your ultimate goal, we suggest the actual Cisco 350-801 dumps for your Implementing and Operating Cisco Collaboration Core Technologies exam preparation to use as your guideline.
NEW QUESTION 29
Refer to the exhibit.
The SDP offer/answer has been completed successfully but there is no DTMF when users press keys. What is the cause of the issue?
- A. Payload type 110 was negotiated rather than type 101.
- B. DTMF was not negotiated on the call.
- C. G.729 rather than G.711ulaw was negotiated.
- D. DTMF was negotiated properly in these messages.
Answer: A
NEW QUESTION 30
What dialed number match this cisco UCM route pattern?
1[23]XX
- A. 1200 through 1399 only
- B. 1200 through 1300 only
- C. 12300 through 12399 only
- D. 1230 through 1239 only
Answer: B
NEW QUESTION 31
Which two protocols does Cisco IM and Presence use to authenticate Jabber? (Choose two.)
- A. XMPP
- B. AXL
- C. SOAP
- D. QBE
- E. TCP
Answer: A,C
NEW QUESTION 32
On a cisco catalyst switch which command is required to send CDP packets on a switch port that configures a cisco IP phone to transmit voice traffic in 802.1q frames tagged with the voice VLAN ID 221?
- A. Device(config-if)# switchport access vlan 221
- B. Device(config-if)# switchport trunk allowed vlan 221
- C. Device(config-if)# switchport vlan voice 221
- D. Device(config-if)# switchport voice vlan 221
Answer: D
NEW QUESTION 33
Refer to the exhibit.
A call is failing to establish between two SIP Devices. The Called device answer with this SDP. Which SDP parameter causes this issue?
- A. The RTP port is set to 0.
- B. The calling device did not offer a ptime value.
- C. The payload for G.711ulaw must be 18.
- D. The media stream is set to sendonly.
Answer: A
NEW QUESTION 34
An administrator has been asked to implement toll fraud prevention in Cisco UCM Which tool is used to begin this process?
- A. Cisco Unified Real-Time Monitoring Tool
- B. Cisco UCM class of service
- C. Cisco Unified Mobility
- D. Cisco UCM Access Control Group restrictions
Answer: B
NEW QUESTION 35
A network administrator deleted a user from the LDAP directory of a company. The end user shows as Inactive LOAP Synchronized User in Cisco Unified Communications Manager. Which step is next to remove this user from Cisco Unified Communications Manager?
- A. Restart the Dirsync service after the user is deleted from LDAP directory.
- B. Wait 24 hours for the garbage collector to remove the user.
- C. Delete the user directly from Cisco Unified Communications Manager
- D. Execute a manual sync to refresh the local database and delete the end user.
Answer: A
NEW QUESTION 36
Which Cisco Unified Communications Manager service parameter should be enabled disconnect a multiparty call when the call initiator hangs up?
- A. Block OffNet To OffNet Transfer
- B. Drop Ad Hoc Conference
- C. H.225 Block Setup Destination
- D. Enterprise Feature Access Code for Conference
Answer: B
Explanation:
Section: Infrastructure and Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmsys/ CUCM_BK_SE5FCFB6_00_cucm-system-guide-100/CUCM_BK_SE5FCFB6_00_cucm-system-guide-
100_chapter_011000.html#CUCM_TK_DFC66444_00
NEW QUESTION 37
An engineer must manually register an analog port with cisco UCM using the MGCP protocol. Which commands are required?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: A
NEW QUESTION 38
An administrator installs a new Cisco Telepresence video endpoint and receives this error: "AOR is not permitted by Allow/Deny list." Which action should be taken to resolve this problem?
- A. Reboot the VCS server and attempt reregistration.
- B. Upload a new policy In VCS.
- C. Correct the restriction policy settings.
- D. Change the SIP trunk configuration.
Answer: C
NEW QUESTION 39
Refer to the exhibit. Which codec should an engineer select for a call mode between "Dallas-REG" & "Austin-REG"?
- A. G.729
- B. G.711
- C. OPUS
- D. MP4A-LATM
Answer: A
NEW QUESTION 40
Which Cisco Unified Communications Manager configuration is required for SIP MWI integrations?
- A. Enable "Accept unsolicited notification" on the SIP Trunk Security Profile.
- B. Select "Redirecting Diversion Header Delivery - Inbound" on the SIP trunk.
- C. Enable "Accept presence subscription" on the SIP Trunk Security Profile.
- D. Select "Redirecting Diversion Header Delivery - Outbound" on the SIP trunk.
Answer: B
NEW QUESTION 41
Users dial a 9 before a 10-digit phone number to make an off-net call. All 11 digits are sent to the Cisco Unified Border Element before going out to the PSTN The PSTN provider accepts only 10 digits. Which configuration is needed on the Cisco Unified Border Element for calls to be successful?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: A
NEW QUESTION 42
An engineer must configure an MGCP gateway and register it to Cisco Unified Communications Manager.
Which prerequisite must be met before applying the gateway commands to enable MGCP?
- A. The MGCP gateway and the Cisco Unified CM must be able to communicate aver ports 5060 and 5061.
- B. Cisco Unified CM and the MGCP gateway must utilize the SIP OPTIONS ping feature to monitor status.
- C. The MGCP gateway must have voice service VoIP configured.
- D. The MGCP gateway and the Cisco Unified CM must be able to communicate over ports 2427, 2428, and
2727.
Answer: D
Explanation:
Section: Cisco IOS XE Gateway and Media Resources
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/ios/voice/cminterop/configuration/guide/12_4t/ vc_12_4t_book/vc_ucm_mgcp_gw.html
NEW QUESTION 43
When a phone is registered over Mobile and Remote Access, where does it register?
- A. Cisco Unified Communications Manager
- B. Expressway-C
- C. Expressway-E
- D. Cisco Unified Presence Server
Answer: C
Explanation:
Explanation/Reference:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/ cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_01011010.html
NEW QUESTION 44
Refer to the exhibit.
AN engineer configures a VoIP dial peer on a Cisco gateway. which codec is used?
- A. G.711ulaw
- B. G.729r8
- C. No codec is used (missing codec command).
- D. G.711alaw
Answer: B
NEW QUESTION 45
Which two protocols should be configured for the Cisco Unity Connection and Cisco UCM integration? (Choose two.)
- A. MGCP
- B. SIP
- C. RTP
- D. SCCP
- E. H.323
Answer: B,D
Explanation:
Section: Protocols, Codecs, and Endpoints
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/connection/11x/design/guide/b_11xcucdg/ b_11xcucdg_chapter_00.html#ID-2342-00000133
NEW QUESTION 46
An engineer must extend the corporate phone system to mobile users connecting through the internet with their own devices. One requirement is to keep this as simple as possible for end users. Which infrastructure element achieves these goals?
- A. Cisco Express Mobility
- B. Cisco Unified Instant messaging and presence
- C. Cisco Expressway-C and Expressway-E
- D. Cisco Unified Border Element
Answer: C
NEW QUESTION 47
A user dials 9011841234567 to reach Vietnam. Which steps send the call to the PSTN provider as
011841234567?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: A
NEW QUESTION 48
......
100% Free 350-801 Demo-Trial [Pdf], get it now: https://drive.google.com/open?id=1LPBpUtecPYUByUnd7lKUBD2O5Ocn8wRG
Accurate & Verified Answers As Seen in the Real Exam here: https://www.examdumpsvce.com/350-801-valid-exam-dumps.html
