Practice Examples and Dumps & Tips for 2023 Latest 350-501 Valid Tests Dumps
Latest [Jul 15, 2023] 100% Passing Guarantee - Brilliant 350-501 Exam Questions PDF
NEW QUESTION # 110 
Refer to the exhibit. This output is included at the end of an output that was provided by a device using NETCONF.
What does the code show?
- A. It shows that the running configuration is blank.
- B. It shows the hostname of the device as rpc-reply.
- C. It shows NETCONF uses remote procedure calls.
- D. It shows that the full configuration is being modeled by YANG.
Answer: C
Explanation:
Section: Automation and Assurance
NEW QUESTION # 111
Refer to the exhibit.
Refer to the exhibit. ISP A provides MPLS L3VPN service to customer A with BGP as the external routing protocol. Customer A has just opened a new branch office in London and requested the service provider to implement lossless service between its two offices. The LDP is enabled over the MPLS backbone and label exchange is working normally. Which action must the ISP engineering team take to enable the service?
- A. Configure BGP address family VPNv4.
- B. Configure IGP LDP synchronization
- C. Configure LDP and redistribute the route from EIGRP.
- D. Configure IGP and redistribute the route from BGP.
Answer: B
NEW QUESTION # 112
Refer to the exhibit. An engineer configured BGP summarization on a customer's network.
Which route is advertised to BGP peers?
- A. 192168.0.5/30
- B. 192.0.0.0/16
- C. 192.168.0.0/16
- D. 192.168.1.0/24
Answer: C
NEW QUESTION # 113
Refer to the exhibit:
Which command is used to complete this configuration for QoS class-based marking?
- A. PE-A(config-pmap-c)#fair-queue
- B. PE-A(config -pmap-c)#priority
- C. PE-A(config-pmap-c)#set dscp ef
- D. PE-A(config-pmap-c)#random-detect
Answer: C
NEW QUESTION # 114
Which two actions describe ISP delegation to PCE servers? (Choose two)
- A. removing TE re-optimization timer timeouts
- B. changing the precedence of any of the PCE servers
- C. adding a new PCE server with lower precedence than the primary PCE
- D. adding a new PCE server with higher precedence than the primary PCE
- E. entering the mpls traffic-eng reoptimize command
Answer: A,C
NEW QUESTION # 115
Refer to the exhibit:
Which statement describes this configuration?
- A. Router 1 can be remotely managed by the CLI using Telnet
- B. Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only
- C. Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session
- D. Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration
Answer: D
NEW QUESTION # 116
Drag and Drop Question
Drag and drop the BGP Best Path Algorithm rules from the left into the corresponding order of importance on the right.
Answer:
Explanation:
NEW QUESTION # 117
Refer to the exhibit.
A network operator must configure CSR1 interlaces GigabitEihernet2 and GigabitEthemet to rewrite VLAN tags 12 and 21 for traffic between R1 and R2 respectively. Which configurator accomplishes this task?
A)
B)
C)
- A. Option B
- B. Option A
- C. Option C
IF bridge domain on both interfaces are 10
Answer: C
NEW QUESTION # 118
What is the role of NSO?
- A. Provides network monitoring services for Layer 3 devices.
- B. Controls the turn-up of a device.
- C. Provides public cloud services for customers that need Internet access.
- D. Maintains data storage.
Answer: B
NEW QUESTION # 119
Which utility can you use to locate MPLS faults?
- A. EEM
- B. MPLS traceroute
- C. QoS
- D. MPLS LSP ping
Answer: B
Explanation:
Section: MPLS and Segment Routing
NEW QUESTION # 120
Refer to the exhibit.
A network operator must configure CSR1 interlaces GigabitEihernet2 and GigabitEthemet to rewrite VLAN tags 12 and 21 for traffic between R1 and R2 respectively. Which configurator accomplishes this task?
A)
B)
C)
- A. Option B
- B. Option A
- C. Option C
Answer: C
NEW QUESTION # 121
Refer to the exhibit.
An engineer must configure router R2 as the new P router in the network. Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adjacencies?
A)
B)
C)
D)
- A. Option
- B. Option
- C. Option
- D. Option
Answer: C
NEW QUESTION # 122
Refer to the exhibit:
Which statement about the status of the neighbor relationship between R1 and R2 is true?
- A. The neighbor relationship is down because the two routers are in the same subnet.
- B. The neighbor relationship is up because R2 is level 1 and level 2 router.
- C. The neighbor relationship is down because the two routers are configured with different area types
- D. The neighbor relationship is down because R2 is operating as a Level 1 router and the two routers are in different area
Answer: D
NEW QUESTION # 123
Refer to the exhibit. Which command is used to complete this configuration for QoS class-based marking?
- A. PE-A(config-pmap-c)#priority
- B. PE-A(config-pmap-c)#fair-queue
- C. PE-A(config-pmap-c)#set dscp ef
- D. PE-A(config-pmap-c)#random-detect
Answer: C
NEW QUESTION # 124
Refer to the exhibit:
After implementing a new design for the network, a technician reviews the pictured CLI output as part of the MOP.
Which two statements describe what the technician can ascertain from the ImpNull output? (Choose two.)
- A. Label 3 is in use for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10
- B. Penultimate Hop Popping is in use for the prefix displayed
- C. Label 0 is used for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10
- D. Label 0 is used for the prefix displayed but will not be part of the MPLS label stack for packets destined for 192 168.10.10.
- E. Ultimate Hop Popping is in use for the prefix displayed.
Answer: A,C
NEW QUESTION # 125
Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?
A)
B)
C)
D)
- A. Option B
- B. Option A
- C. Option C
- D. Option D
Answer: C
NEW QUESTION # 126
An engineer is implementing MPLS to monitor within the MPLS domain. Which must the engineer perform to prevent packets from being forwarded beyond the service provider domain when the LSP is down?
- A. Option B
- B. Option A
- C. Option D
- D. Option C
Answer: A
NEW QUESTION # 127
......
350-501 are Available for Instant Access: https://www.examdumpsvce.com/350-501-valid-exam-dumps.html
350-501 Certification – Valid Exam Dumps Questions Study Guide: https://drive.google.com/open?id=1A2D8D93J_0sET7lAefM2tFoyc8zYybqS
